Hide Table of Contents

Deleting and Filling Faces

To delete and fill surfaces:

  1. Click Delete Face on the Surfaces toolbar, or Insert > Face > Delete.

    The Delete Face PropertyManager appears.

  2. In the graphics area, click the faces you want to delete.

    The names of the faces appear under Faces to delete .

  3. Under Options, click Delete and Fill.

    The system deletes the faces and replaces them with a single face.

    • Tangent fill cleared. The fill use contact edges.
    • Tangent fill selected. The fill uses tangent edges.

  4. Click OK .

    The faces are deleted, and are filled by a single unbroken surface.

    Before Delete and Fill After Delete and Fill



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Deleting and Filling Faces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.