Hide Table of Contents

Loading Envelopes as Lightweight or Read-Only

You can set system options to load envelopes as lightweight or read-only.

By default, when you open an assembly, envelope components are loaded in the same mode as other components. However, you can set system options to automatically load envelopes as lightweight or read only (or both).

To load envelopes as lightweight or read-only:

  1. Click Options Tool_Options_Standard.gif (Standard toolbar) or Tools > Options.
  2. On the System Options tab, click Assemblies.
  3. Under Envelopes, select one or both:
    Option Description
    Automatically load lightweight Loads all envelopes as lightweight.
    Load read-only Loads all envelopes as read-only.
  4. Click OK.

    The next time you open an assembly that contains envelopes, the envelopes are loaded per the options you selected.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Loading Envelopes as Lightweight or Read-Only
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.