Hide Table of Contents

Replacing Forming Tools

After you insert a forming tool in a model, you can replace the forming tool with another one.

  1. In the FeatureManager design tree of the target part, right-click the forming tool FM_forming_tool.gif and click Replace Form Tool.
  2. In the dialog box, navigate to the new forming tool and click Open.
  3. Set options in the PropertyManager and click PM_OK.gif.

    The original forming tool is replaced with the new forming tool.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replacing Forming Tools
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.