Hide Table of Contents

Creating a Simple Hole

Hole creates various types of hole features in the model. You place a hole and set a depth on a planar face. You can specify its location by dimensioning it afterwards.

Recommendations

In general, it is best to create holes near the end of the design process. This helps you avoid inadvertently adding material inside an existing hole. Also, if you are creating a simple hole which does not require additional parameters, use Simple Hole.

The second option, using Hole Wizard introduces additional parameters that are not required with simple holes. Simple Hole provides better performance than Hole Wizard for simple holes. Hole Wizard creates holes with complex profiles, such as Counterbore or Countersunk.

To create and position a simple hole:

  1. Select a planar face on which to create the hole.
  2. Click Simple Hole (Features toolbar) or Insert > Features > Hole > Simple.
  3. In the PropertyManager, set the options.
  4. Click OK to create the simple hole.
  5. Right-click the hole feature in the model or the FeatureManager design tree, and select Edit Sketch.
  6. Add dimensions to position the hole. You can also modify the hole diameter in the sketch.
  7. Exit the sketch or click Rebuild .

  8. To change the diameter, depth, or type of the hole, right-click the hole feature in the model or the FeatureManager design tree, and select Edit Feature. Make the necessary changes in the PropertyManager, and click OK .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Simple Hole
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.