Hide Table of Contents

Sketching Infinite Lines

You cannot convert an infinite length line to a finite length line. However you can convert a finite length line to infinite length.

To create lines of infinite length:

  1. Click Line Tool_Line_Sketch.gif (Sketch toolbar) or click Tools > Sketch Entities > Line.
  2. In the Insert Line PropertyManager:
    1. Under Orientation, select an orientation.
    2. Under Options, select Infinite length.
  3. Click to sketch one or more lines.
  4. In the Line Properties PropertyManager, do any of the following:
    • Under Options, select For construction.
    • Under Parameters, set a value for Angle PM_angle.gif (if you selected As sketched or Angle as Orientation).
  5. Click PM_OK.gif to return to the Insert Line PropertyManager where you can change settings or exit the sketch.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketching Infinite Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23