Hide Table of Contents

Viewing Missing Reference Ghosts

You can view ghosts that give you information about the size, location, and type of references that are missing.

  1. Create a part similar to the one shown.



  2. Expand the extrude feature and edit its sketch to remove the upper-right corner of the sketch, approximately as shown.

  3. Exit the sketch.

    The What's Wrong dialog box reports an error in the fillet feature, which also shows as an error in the FeatureManager design tree.

  4. Close the dialog box.
  5. In the FeatureManager design tree, right-click the fillet feature and select Edit Feature .

    In the PropertyManager, **Missing**Edge<1> appears in Edge, Faces, Features and Loops . A ghost of the missing edge used by the fillet appears in the graphics area.

  6. Select **Missing**Edge<1> in the PropertyManager.

    The missing reference ghost is highlighted.

  7. Select the top-most edge as a replacement for the missing edge, and the lower edge as a new edge for Edges, Faces, Features and Loops .

    The ghost disappears from the graphics area. **Missing**Edge<1> disappears from the PropertyManager.

  8. Click .

    The fillet no longer shows an error in the PropertyManager.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Viewing Missing Reference Ghosts
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.