Hide Table of Contents

Adding Components from an Open Document Window

You can add components to an assembly by dragging from an open document window. Depending on how you drag the component, you can align it with the assembly origin or add SmartMates.

Dragging Components from the FeatureManager Design Tree

To add components by dragging from the FeatureManager design tree:

  1. Open the destination assembly document, and open the source document (either the component document itself, or another assembly document that contains the component).
  2. Click Window > Tile Horizontally (or Tile Vertically).
  3. Drag the component icon from the FeatureManager design tree of the source window to the destination assembly window. You can inference the assembly origin.

    You can also drag entire subassemblies.

    If the component has multiple configurations, you can select which configuration to insert. Select the ConfigurationManager tab in the source window, then drag the name of the configuration.

Dragging Components from the Graphics Area

To add components by dragging from the graphics area:

  1. Ctrl + drag the component from the graphics area of the source window into the graphics area of the assembly window, but do not drop it immediately. Use one of the following entities to drag the component: a linear or circular edge, a temporary axis, a vertex, a planar face, or a cylindrical/conical face. You can inference the assembly origin.

    You can also Ctrl + drag a component from a subassembly.

    When the pointer is over an entity of another component that is a potential mate partner, the pointer changes to indicate the mate or mates that will result if the component is dropped at this location. A preview of the component snaps into place.

  2. Drop the component.

    The mates are added automatically.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Components from an Open Document Window
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.