Hide Table of Contents

Using Display States in Parts

In the Display Pane, you can add new display states to a part, change from one display state to another, and rename display states.

To add a display state to a part:

  1. Right-click anywhere in the Display Pane and click Add Display State.
  2. Type a name for the new display state in the field that appears at the top of the Display Pane.

    The name of the new display state appears in angle brackets after the configuration name at the top of the FeatureManager design tree.

To change display states:

Do one of the following:
  • Right-click anywhere in the Display Pane, click Activate Display State, and select a display state.
  • When the Display Pane is hidden, right-click in the top right corner of the FeatureManager design tree, and select a display state.
  • Use Customize to add the Change Display State command to any toolbar.
Display State-1 Display State-2

To rename a display state:

  1. Ensure the display state is active.
  2. Right-click anywhere in the Display Pane and click Rename Display State.
  3. Type a new name for the display state in the field at the top of the Display Pane.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Display States in Parts
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.