Hide Table of Contents

Creating Slots from the Hole Wizard

You can create counterbored, countersunk, and straight slots from the Hole Wizard.

To create a Hole Wizard slot for a part:

  1. Select a face and click Hole Wizard (Features toolbar) or Insert > Features > Hole > Wizard.
  2. In the PropertyManager, on the Type tab, for Hole Type, select a slot type:
    Option Description
    Counterbore Slot PM_HoleWiz_cbore_slot.png
    Countersink Slot PM_HoleWiz_csink_slot.png
    Straight Slot PM_HoleWiz_slot.png
  3. Under Hole Specifications, for Slot length PM_HoleWiz_Slot_Length.png, enter a value.
  4. Select other options and click PM_OK.gif.
You can also create Hole Wizard or hole series slots in assemblies.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Slots from the Hole Wizard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.