Hide Table of Contents

OLE Object Property

Lets you specify the size and scale of the OLE object inserted in a SOLIDWORKS document.

To set the size or scale of an OLE object:

  1. Right-click the OLE object in the document and select Properties.
  2. In the dialog box, type a decimal value for the Width, Height, or Scale into the corresponding boxes.
  3. Select Sharpen zoomed state if the object is blurred when you zoom in.

    Sharpen zoomed state applies only to the image on screen. Print quality is not affected.

  4. Click OK.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   OLE Object Property
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.