> Design Checker > Feature Checks

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Welcome to SOLIDWORKS Design Checker

Drawing Document Checks

Part Document Checks

Assembly Document Checks

Feature Checks

Design Studies in SOLIDWORKS

Detailing and Drawings

Sustainability Products

Feature Checks

On the Feature Checks tab , click any of the following to add to the Build Checks requirements:

Feature Error Warnings

Identifies features that have rebuild errors or warnings.

Fully Defined Sketch

Identifies sketches that are not fully defined.

Standard Hole Size

Verifies if holes in the part or assembly document comply with the standard hole sizes created with Simple Holes or the Hole Wizard.

Activate Standard Hole Sizes through Feature Checks .

For example, this check included a Custom Throughhole with a non-standard diameter of 0.3420.

Parameter Name	Remarks
Standard Hole Sizes	Custom Throughhole Diameter: 03240
Standard Hole Sizes	Standard Throughhole Diameter: 0.24320

Tapered Drill and Tapered are not supported for Legacy Hole types.

Suppressed Feature

Cycles through all features and model configurations for suppressed parts.

For Suppressed Components

, and Suppressed Features

The check fails only if the condition exists in all configurations.
Setting the Criticality level is the only user interface.

Feature Positioning Check

The Feature Positioning check verifies that the active document has no 2D or 3D sketches positioned with references to fillet or chamfer edges.

Click Feature Positioning under Feature Checks to add to the Build Checks.

Search 'Feature Checks' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Feature Checks
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.