Hide Table of Contents

Combining the Different Sheet Metal Design Methods

Parts that are originally created as sheet metal have different features than parts that are created, and then converted to sheet metal. However, you can add sheet metal-specific features to parts converted to sheet metal.

As soon as you add a sheet metal-specific feature, (a Miter Flange Tool_Miter_Flange_Sheet_Metal.gif, an Edge Flange Tool_Edge_Flange_Sheet_Metal.gif, and so on), bends for new sheet metal features are stored under each individual feature instead of under Flatten-Bends1 FM_SHM_flatten_bends.gif or Process-Bends1 FM_SHM_process_bends.gif. Additionally, all new bends are listed under the Flat-Pattern1 fm_flat_pattern.png feature.

To flatten the part, unsuppress Flat-Pattern1 fm_flat_pattern.png rather than suppressing Process-Bends1 FM_SHM_process_bends.gif.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Combining the Different Sheet Metal Design Methods
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.