Hide Table of Contents

Creating a Sheet Metal Part Using Sharp Bends

When bending sheet metal, you may want to create sharp bends instead of round bends.

To create a sheet metal part with sharp bends:

  1. Create a part by sketching the part profile, then extruding a thin-feature part.
  2. Click Insert Bends Tool_Insert_Bends_Sheet_Metal.gif or click Insert > Sheet Metal > Bends.
  3. In the PropertyManager, under Bend Parameters:
    • Select the fixed face on the model. The fixed face remains in place when the part is flattened. The name of the face is displayed in the Fixed Face or Edge PM_shm_Fixed_Face.gif box.
    • Type the Bend Radius PM_draft_angle.gif.
  4. Under Bend Allowance, select from the following options: Bend Table, K-Factor, Bend Allowance, Bend Deduction, or Bend Calculation.
    • If you selected K-Factor, Bend Allowance, or Bend Deduction, enter a value.
    • If you selected Bend Table or Bend Calculation, select a table from the list, or click Browse to browse to a table.
  5. If you want relief cuts added automatically, select the Auto Relief check box, then choose the type of relief cut. If you choose Rectangular or Obround, then you must specify a Relief Ratio.

    The options and values you specify for bend radius, bend allowance, and auto relief are shown as the default settings for the next new sheet metal part that you create.

  6. Click PM_OK.gif.

    A bent sheet metal part is created whose dimensions in the flattened state reflect the specified bend allowance and radius values.
    sheet_metal_sharp_bends.gif



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Sheet Metal Part Using Sharp Bends
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.