Hide Table of Contents

Debug Add-ins Dialog Box

Use the Debug Add-in dialog box to debug an add-in without adding it to a vault. The add-in is loaded from the location registered by the compiler so that other users of the vault are not affected.

Do not add the add-in to be debugged by selecting New Add-in command. After you have debugged the add-in, click Remove Add-in. Users of computers connected to the vault can then use the New Add-in command to install the add-in.

To display this dialog box:

Right-click Add-ins and select Debug Add-ins.

Add-ins installed for debugging on this machine Installed add-ins.
Add Add-in Select an add-in to install for debugging.
Remove Add-in Uninstall the selected add-in.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Debug Add-ins Dialog Box
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS PDM 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.