Hide Table of Contents

Converting ECAD Files to ProStep EDMD

You can convert any type of supported ECAD file to a ProStep EDMD Baseline file.

Before sending ProStep EDMD file information, you must enable ProStep EDMD file syncing.

  1. Open the ECAD file in the CircuitWorks application.
  2. On the EDMD tab, click Sync with ECAD sw_sync_tool.gif.
    The Sync with ECAD dialog box displays a summary of the messages to be sent with the ProStep EDMD data.
  3. In the dialog box, click <Click to edit note> to add an optional note, and click OK.
    New ProStep EDMD data is saved to the shared folder as a ProStep EDMD Baseline file.
    Changed ProStep EDMD data is saved as a ProStep EDMD Changes file.
    If you sync by email, in addition to placing the ProStep EDMD file in the shared folder, the CircuitWorks software attaches new ProStep EDMD file to an outgoing email.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Converting ECAD Files to ProStep EDMD
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23