Hide Table of Contents

Move, Resize, and Copy Planes

You can move, resize, and copy planes using the plane handles and edges.

Displaying Plane Handles

To display the plane’s handles:

Do one of the following:
  • Click the plane’s name in the FeatureManager design tree or in the graphics area.
  • Click the edge of the plane.
    PLANE-01.gif
Using the plane’s handles and edges, you can do the following:
  • Resize the plane by dragging a corner or edge handle.
  • Move the plane by dragging the edge of the plane.
  • Copy the plane by selecting a plane in the graphics area. Then hold down the Ctrl key and, using the edge, drag to a new location. An offset plane is created.

Modifying the Offset Distance, Angle, or Distance Between Planes

To modify the offset distance, angle, or distance between planes:

  1. Click the plane to display the offset distance or angle.
  2. Do one of the following:
    • Click the dimension or angle to enter Quick Edit mode, and type a new value.
    • Drag the manipulator at the end of the dimension line using Instant3D rulers to set the offset distance.
      1. Right-click the name of the plane in the FeatureManager design tree.
      2. Select Edit Feature.
      3. In the PropertyManager, enter new values to define the plane, then click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Move, Resize, and Copy Planes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59