Hide Table of Contents

About Manual Mode for Parting Surfaces

When you create or edit parting surfaces in manual mode, you can modify the surface directions generated by the Parting Surface command.

To open the Parting Surface PropertyManager do one of the following:
  • Click Parting Surfaces (Mold Tools toolbar).
  • Click Insert > Molds > Parting Surface.
  • Select a Parting Surface feature in the FeatureManager design tree and click Edit Feature fm_edit_feature.gif.

To activate manual mode for parting surfaces, in the PropertyManager, for Options, select Manual Mode.

You can adjust the parting surface as follows:
  • Drag a handles to prevent the intersection of overlapping surfaces.
  • Redefine the surface region between two vertices to specify a filled surface:
    1. Right-click a vertex at the edge of the part and select Start fill surface region.
    2. Right-click a second vertex at the edge of the part and select End fill surface region.
Example: Parting Surface Generated Without Manual Mode has Crossed Surface Lines
molddesigneditpartingsurfacenomanual.gif
Example: Manual Mode Generates Handles for Moving Surface Lines
molddesignpartingsurfwithmanual.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   About Manual Mode for Parting Surfaces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.