Hide Table of Contents

Open Model in Position

When you open a part or subassembly from an assembly or drawing document, you can open the model in the same view position and orientation as seen in the assembly or drawing view.

Do one of the following:

  • In a drawing, to open a model in position, right-click the part or subassembly in the FeatureManager design tree or the graphics area and select Open Assembly In Position or Open Part In Position from the context toolbar.
  • In an assembly, left-click or right-click the part or subassembly in the FeatureManager design tree or the graphics area and select Open Assembly In Position or Open Part In Position from the context toolbar.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Open Model in Position
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26