Hide Table of Contents

Replacing Sketches of Projected Curves

You can replace one or more of the sketches that make up a projected curve of two sketches projected onto one another.

To replace a sketch in a projected curve:

  1. Right-click the Curve feature in the FeatureManager design tree, or right-click the curve in the graphics area, and select Edit Feature fm_edit_feature.png.
    The Curve PropertyManager appears.
  2. Choose one of the following methods to clear the unwanted sketch from the Sketch to Project PM_sketch_to_project.gif box:
    • Click the sketch in the flyout FeatureManager design tree.
    • Click the sketch in the graphics area.
    • Select the sketch in the Sketch to Project PM_sketch_to_project.gif box under Selections, and press Delete.
  3. Select the replacement sketch in either the flyout FeatureManager design tree or in the graphics area, then click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replacing Sketches of Projected Curves
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.