Hide Table of Contents

Suppressing and Deleting Sensors

You can suppress one or more sensors at a time.

To suppress or unsuppress sensors:

In the FeatureManager design tree, in the Sensors folder, select one or more sensors and do one of the following:
  • Click Edit > Suppress (or Unsuppress) and then select This Configuration, All Configurations, or Specified Configurations.
  • Right-click and select Suppress or Unsuppress (applies to only the current configuration).
  • Set the suppression state in a design table using:
    • Column header: $STATE@ sensor_name (for example, $STATE@Mass1)
    • For each configuration: S for suppressed or U for unsuppressed

Suppressed sensors appear in gray in the FeatureManager design tree, and are not calculated for the model.

To delete a sensor, right-click it and select Delete . The sensor is removed from all configurations of the model.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Suppressing and Deleting Sensors
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.