Hide Table of Contents

Trimming with Corner

Extends or trims two sketch entities until they intersect at a virtual corner.

To trim with the Corner option:

  1. Right-click the sketch and select Edit Sketch.
  2. Click Trim Entities Tool_Trim_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Trim.
  3. In the PropertyManager, under Options, select Corner PM_trim_trim_corner.gif.
  4. Select the two sketch entities you want to joined.
    Depending on the sketch entities and their relative position to each other, the software extends or trims each entity to join them. A message appears when the operation cannot be completed.
  5. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Trimming with Corner
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.