Hide Table of Contents

Installing Add-ins for Debugging

To install an add-in for debugging:

  1. Expand the vault where the Add-in will be used.
  2. Right-click Add-ins and select Debug Add-ins.
  3. In the Debug Add-ins dialog box, click Add Add-in.
  4. In the Open dialog box, navigate to the location of the .dll for the add-in, select it, and click Open.
The add-in is added to the list of add-ins for debugging, which shows the path to the .dll and its class ID.

To make the add-in available to be installed for use by all computers connected to the vault, select it and click Remove Add-in.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Installing Add-ins for Debugging
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS PDM 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.