Hide Table of Contents

Permitting Task Execution

To execute tasks on a computer, you must configure the computer to be a task host. You grant task execution permission for each vault where tasks will be run.

For the Convert, Design Checker, and Print tasks, SOLIDWORKS must be installed on the systems you select for task execution. When the task runs, SOLIDWORKS is opened briefly. If you configure a task to convert assemblies that use Toolbox parts, to prevent SOLIDWORKS from hanging, set the Hole Wizard/Toolbox path in SOLIDWORKS to the Toolbox location in the vault. See Configuring Toolbox in SOLIDWORKS PDM and SOLIDWORKS.

To configure a computer as a task host:

  1. On a computer you are configuring to host tasks, use File Explorer to log in to the vault.
  2. In the notification area to the right of the taskbar, click the SOLIDWORKS PDM icon and click Task Host Configuration.
  3. In the Task Host Configuration dialog box, select the vault where you want to permit task execution.
    The task add-ins installed in the vault are listed.
  4. Under Permit, select the add-ins that can execute tasks on this computer.
  5. Repeat steps 3 and 4 for each vault where you want to permit task execution.
  6. Click OK.
When an administrator selects the execution method for a task, the computer appears in the list of computers you can select for task execution.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Permitting Task Execution
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.