Hide Table of Contents

Creating Conditions for Workflows

You can create conditions to control how SOLIDWORKS PDM assigns files and items to workflows.

To create conditions for workflows:

  1. Expand Workflows, then right-click a workflow and select Properties.
  2. Under Conditions, click New .
  3. Under Type, click Click here to change, select a condition type, and provide additional input as required by the type.
  4. Optionally add more conditions.

    By default, conditions are AND conditions, meaning all conditions must be true for the file or item to enter the initial state of the workflow. You can also define OR conditions, meaning at least one condition must be true.

  5. To define OR conditions:
    1. Click Or to create an OR container.
    2. Drag two or more conditions into the OR container.
  6. When you are done adding conditions or otherwise editing the category or workflow, click OK.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Creating Conditions for Workflows
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS PDM 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.