Inserts images into reports. Images that you insert capture the current state of the model, mesh, or results.
If any of these change, these images do not update the next time you publish the report.
To access this PropertyManager, do one of the following:
After you click , an image appears in the Simulation study tree under the selected reports and in the Images folder under Report. The report section associated with the image appears in parentheses after the image name.
(Available when Current View is selected.)
Lets you specify which load, fixture, or connector annotations to include in the image. The annotation information is derived from the definition of the corresponding load, fixture, or connector.
To insert an image in all reports, in the Images folder, right-click the image and click Include in All Reports.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2016 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.