Hide Table of Contents

Defining Goals

Define goals to specify your objective functions for the Optimization Design Study. (Not available in SOLIDWORKS Standard and SOLIDWORKS Professional.)

  1. On the Variable View or Table View tab of the design study, in Goals section, do one of the following:
    • Select a predefined sensor from the list.
    • Select Add Sensor, define a sensor, and select the newly defined sensor from the list.
    The sensor name appears in the Goals section.
  2. For the goal, if you defined multiple studies of the same type, select the simulation study to run and track the value of the sensor.
  3. For the goal, select one of the following:
    • Minimize.
    • Maximize.
    • Is exactly. Type an exact value. For example, to find the optimal design that causes a 1mm deflection at the tip of a cantilever, type 1mm.
  4. Repeat steps 1 and 2 to define additional goals.
  5. For multiple goals, type the weight of each goal, for example 5.
    The weight of a goal to optimize represents its relative importance. The higher the weight of the goal, the more important it is to optimize that goal. The program modifies the final weight of the goal as: (weight of the goal you type)/(sum of weights of all goals you type).


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Defining Goals
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.