Hide Table of Contents

Gravity PropertyManager

Gravity (Basic Motion and Motion Analysis only) is a simulation element that moves components around an assembly by inserting a simulated gravitational force.

To open the Gravity PropertyManager:

From an assembly, click Gravity (MotionManager toolbar).

Gravity Parameters

Direction Reference Set a Direction Reference for gravity. You can select:
  • A face to orient gravity parallel to the normal.
  • An edge to orient gravity parallel to the edge.
  • X, Y, or Z to orient gravity in the chosen direction in the assembly reference frame.
Numeric gravity value Set the Numeric gravity value. Default is standard gravity.
You can use only one definition of Gravity in any simulation.

Notes

  • You can define one gravity simulation element per assembly.
  • All components accelerate at the same rate under the effect of gravity regardless of their mass.
  • Motion due to motors supersedes motion due to gravity. If you have a motor moving a component to the left and gravity pulling a component to the right, the component moves to the left, and the power consumption of the motor increases.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Gravity PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.