Hide Table of Contents

Simulation Setup PropertyManager

With SOLIDWORKS Simulation added in, you can perform stress, factor of safety, or deformation analysis of components without setting up loads and boundary conditions. The required loads are obtained automatically from a calculated Motion Analysis study

For each stress analysis result, you can select a component, duration, and start time in the Simulation Setup PropertyManager. You can also modify the mesh density.

To open this PropertyManager, from a Motion Analysis study:

Click Simulation Setup (MotionManager toolbar).

Selection

Component FM_part.gif Displays component on which to calculate stress analysis results.
Select only single-body top-level components for stress analysis.
Start Time Sets start time for an isolated time point or time range.
You can enter a time value or select the time from the MotionManager timeline.
End Time Sets end time for an isolated time point or time range.
Add Time   Includes isolated time point or time range in stress analysis.
You can enter multiple isolated time points or time ranges.

Advanced

Mesh Density Slider adjusts mesh density from Course to Fine.
Check Mesh   Monitors mesh creation and displays mesh progress.
To set up stress analysis for more than one part, click Keep Visible and select another part.
When closing the Simulation Setup PropertyManager, you are prompted to select the component material in the Material dialog box if you have not yet set up the material.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Simulation Setup PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.