Hide Table of Contents

Specifying Torsional Springs or Dampers

You can create a spring that stores energy or a damper that dissipates energy when twisted.

To create a torsional spring or damper:

  1. Open the PropertyManager and select the type:
    • To specify a torsional spring, click Spring (MotionManager toolbar) and click Torsional Spring .
    • To specify a torsional damper, click Damper Tool_Damper.gif (MotionManager toolbar) and click Torsional Damper .
  2. In the first selection box, select the face or edge on the part to which one end of the spring or damper is attached.
    This feature also specifies the torque direction.
    The selected feature and torque vector are highlighted.
    To change the torque vector, in the first selection box, select a second face or edge that defines the required direction. To reverse the torque direction, click flip_dir.png Button.
  3. In the second selection box, select the face or edge on a second part to which the spring or damper is attached.
    Leave the second selection box empty to attach the other end of the spring or damper to ground.
  4. Select other options that specify the spring or damper.
  5. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Specifying Torsional Springs or Dampers
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.