Hide Table of Contents

Setting the Exact Time for Key Points and the Time Bar

To set exact key point time:

  1. Right-click a key point and click Edit Key Point Time .
    • Select Exact Time to enter the exact key point time.
    • Select Offset to shift the current key point time by a value.
  2. Drag the dial, click the spin buttons, or enter a value for the key point time or offset.
    You can enter the values as small as 10-9 sec.
  3. Click .
  4. From the lower right corner of the MotionManager, click Zoom to Fit tool_Zoom_to_Fit_View.png to rescale the timeline view if necessary.
To specify an exact time for the time bar, right-click the time bar, and click Move Time Bar.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting the Exact Time for Key Points and the Time Bar
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.