Hide Table of Contents

Configuration Publisher Dialog Box

In the Configuration Publisher dialog box, you create an interface for specifying configurations of parts and assemblies. You can use the interface in SOLIDWORKS and in 3DContentCentral.

You can start with a model with one or more configurations. The model must contain a design table (single or multiple rows).

To access the Configuration Publisher dialog box:

At the top of the ConfigurationManager tab, right-click the model name and click Configuration Publisher.

In the Configuration Publisher dialog box, you drag controls from the palette on the left onto the Edit tab in the pane in the center. In the pane on the right, you set attributes for each control. Available options vary depending on the control type and whether the model has a single-row or multiple-row design table.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configuration Publisher Dialog Box
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.