Hide Table of Contents

Finishing the Interlock Surface

Lofted Surface Tool_Lofted_Surface_Surfaces.gif mold_loft_after_ruled_srf_prvw.gif
Ruled Surface tool_Ruled_Surface_Mold_tools.gif

Use Ruled Surface, rather than Extend Surface to maintain the correct taper.

Extend Surface Tool_Extend_Surface_Surfaces.gif

To facilitate Trim Surface.

Trim Surface Tool_Trim_Surface_Surfaces.gif, using Mutual to remove material adjacent to the horizontal ruled surface.

Knit Surface tool_Knit_Surface_Surfaces.gif after trim.

Create a plane, parallel to Top Plane.

Sketch rectangle to create a planar surface.

Planar Surface tool_Planar_Surface_Surfaces.gif mold_sketch_planar_trim_done.gif
Trim Surface Tool_Trim_Surface_Surfaces.gif, using Standard to trim below the planar surface. mold_mutual_trim_02a.gif
After trim, the planar surface is ready as the basis for tooling split operation. mold_tooling_split_before.gif

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Finishing the Interlock Surface
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.