Hide Table of Contents

Testing Model Health

You can test the health of models before uploading them to 3D ContentCentral.

A sample of possible configurations is tested. Results are reported in a log file that lists the configurations that were tested and whether they rebuilt successfully.

To test a model before uploading it:

  1. In the Configuration Publisher, on the 3DCC Preview tab, click Test.
  2. In the Configuration Tester dialog box, specify the sample size and where to store the log file, and click Begin Test.
    The dialog box reports the percentage of the samples that succeeded. You can view the log file for more details.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Testing Model Health
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59