> Removing Overrides from Subassembly Components

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

SOLIDWORKS Sustainability

Removing Overrides from Subassembly Components

You can remove display setting overrides from subassembly components.

Removing Overrides from One Subassembly Component

To remove overrides from one subassembly component:

Click an icon in the Display Pane for the component and select Clear Override

All display setting overrides for that component are removed.

Removing Overrides from All Subassembly Components

To remove all overrides from all subassembly components:

In the Display Pane, do one of the following:
- Right-click anywhere.
- Click an icon.
Select Clear All Top Level Overrides .
All display setting overrides for all subassembly components are removed.
Display settings for top level components are stored in the display state of the top level assembly. Therefore, they always appear in the normal color intensity (not faded), and are not affected by the commands to clear overrides.

Search 'Removing Overrides from Subassembly Components' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Removing Overrides from Subassembly Components
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.