Hide Table of Contents

Specifying Assembly Use Parameters

The Use section of the Sustainability Task pane lets you specify where the product is used and the energy needs of the product over its lifespan.

To provide assembly Use parameters:

  1. In the Use section of the Sustainability Task pane, select the manufacturing region from the Region drop-down list or by clicking the region in the map.
  2. To specify the energy used during the lifetime of the product, select Energy needs over lifespan.
  3. In the Type of Energy drop-down list, select from:
    • Electricity
    • Natural Gas
    • Diesel
    • Gasoline
    • Kerosene
    • Light Fuel Oil
  4. Specify the Amount of energy and select a time increment. For example, selecting Diesel, typing 2.00, and selecting Hour, indicates that the product will use 2.00 gallons of diesel fuel per hour during its lifetime.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Specifying Assembly Use Parameters
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.