Hide Table of Contents

Editing Sketch Points

You can change the number of sketch points you created with the Segment tool. Previously, you had to delete the points and use the Segment tool again.

To edit sketch points:

  1. Open a sketch on which you previously used the Segment tool.

    You must have created the sketch in SOLIDWORKS 2016 or later.
  2. Right-click an Equidistant relation icon and click Edit Segment Points.
  3. In the PropertyManager, edit the Number of Instances and click .
    The sketch updates with the specified segments.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Editing Sketch Points
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.