Hide Table of Contents

Specifying Component Heights

You can provide the height for each component instance when you design a circuit board.

The height information for a component from an ECAD file appears in the Component Instance Properties panel. For each component instance, you can modify the component height and associate the modified instance with a specific SOLIDWORKS configuration.

The software saves the height modification in the ECAD file. When you build a SOLIDWORKS assembly from the data in CircuitWorks, the software assigns the height to the SOLIDWORKS configuration you specified.

To specify component heights:

  1. In CircuitWorks, open an ECAD file.
  2. In the CircuitWorks feature tree, right-click a component instance and click Properties.
  3. In the Component Instance Properties panel, type the value for Height (mm).
    The value for SOLIDWORKS Configuration is NA if you have not exported the ECAD file to SOLIDWORKS.
  4. Repeat steps 1 and 2 for each component instance.
  5. Click Build Model (SOLIDWORKS section of the Tools tab).
  6. In SOLIDWORKS, on the CircuitWorks CommandManager, click Export to CircuitWorks .
  7. In the CircuitWorks feature tree, in the file you exported from SOLIDWORKS, right-click one of the component instances to which you assigned a height.
    In the Component Instance Properties panel, SOLIDWORKS Configuration shows the configuration associated with the component instance.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Specifying Component Heights
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.