Hide Table of Contents
InsertConnectionPoint Method (IModelDoc2)

Adds a connection point based on the selected point and selected planar item.

.NET Syntax

Visual Basic (Declaration) 
Sub InsertConnectionPoint() 
Visual Basic (Usage) 
Dim instance As IModelDoc2
void InsertConnectionPoint()
void InsertConnectionPoint(); 


If the selection set is not complete, then the Insert Connection Point dialog is displayed.

The connection point is the point on the fitting that defines where the connection to other pipe items begins or ends.


See Also


SOLIDWORKS 2001Plus FCS, Revision Number 10.0

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   InsertConnectionPoint Method (IModelDoc2)
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: API Help (English only) 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.