Hide Table of Contents
SketchSpline Method (IModelDoc2)

Starts a spline, or continues one, using the specified point.

.NET Syntax

Visual Basic (Declaration) 
Sub SketchSpline( _
   ByVal MorePts As System.Integer, _
   ByVal X As System.Double, _
   ByVal Y As System.Double, _
   ByVal Z As System.Double _
) 
Visual Basic (Usage) 
Dim instance As IModelDoc2
Dim MorePts As System.Integer
Dim X As System.Double
Dim Y As System.Double
Dim Z As System.Double
 
instance.SketchSpline(MorePts, X, Y, Z)
C# 
void SketchSpline( 
   System.int MorePts,
   System.double X,
   System.double Y,
   System.double Z
)
C++/CLI 
void SketchSpline( 
&   System.int MorePts,
&   System.double X,
&   System.double Y,
&   System.double Z
) 

Parameters

MorePts
Number of points left to specify the spline after this one (see Remarks)
X
x coordinate in meters
Y
y coordinate in meters
Z
z coordinate in meters

Example

Remarks

MorePts goes from n to 0 in (n+1) calls of this method. When n = 0, the last call is made to this method, and the spline is created. For example, if specifying 5 points, then the value of MorePts ranges from 4 to 0.

In SOLIDWORKS 2005 SP1 and earlier, if a failure occurred in a previous call to ModelDoc2::SketchSpline, then subsequent calls to this method failed. In SOLIDWORKS 2005 SP2 and later, if you specify a negative value for MorePts prior to sending the actual data, then the method reinitializes.

In 2D sketches, z is ignored.

 

See Also

Availability

SOLIDWORKS 2001Plus FCS, Revision Number 10.0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   SketchSpline Method (IModelDoc2)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.