Hide Table of Contents

Curve-to-Curve Contact

When you can model component contact in your assembly with two curves that touch during motion, you can define curve-to-curve contact between the two components.

When the two components make intermittent contact during the motion analysis, curve-to-curve contact applies contact forces to the components, preventing them from moving through each other. You can also constrain the continual contact of two components with curve-to-curve contact.

You can include curve-to-curve contact in a motion study when you can define contact between two parts from two curves that touch in parallel or coincident planes. You can use straight lines, edges, closed contours, splines, arcs, or continuous curves to define the contact.

Continual curve-to-curve contact

Specify continual curve-to-curve contact in a Motion Analysis study when you can use the continual contact between two curves or edges in a plane to define the contact between two components. Continual curve-to-curve contact constrains components to touch throughout the motion.

Intermittent curve-to-curve contact

Specify intermittent curve-to-curve contact in a Motion Analysis study when you can you can use the contact between two curves or edges in parallel planes to define the contact between two components that are not in continual contact.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Curve-to-Curve Contact
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.