Hide Table of Contents

Motion Study Elements Overview

Use the Motion Study elements to model the motion of a component or assembly.

Available elements are:

Motors
Gravity (Motion Analysis and Basic Motion only)
Springs (Motion Analysis and Basic Motion only)
Dampers (Motion Analysis only)
Forces (Motion Analysis only )
Tool_3DContact.gif Contact (Motion Analysis and Basic Motion only )
You can also use the following to model properties of mates for a motion study:
  • Friction
  • Bushings

Motors

Using motors in motion studies, you can apply motion to a component without consideration of mass or inertia. Motion due to a motor supersedes motion due to any other Motion Study element. Any element that tends to resist motor motion increases the power consumption of the motor, but does not slow down the motor motion. You can view this effect, for example, in Motion Analysis results. However, if something causes the reference of the motor direction to change, the motor motion is applied in the new direction. You can select motor motion from a set of defined motor types, or you can use mathematical expressions.

Force Elements

Force elements do not prohibit or prescribe motion. Therefore, they do not add or remove degrees of freedom from your model. Forces may resist motion or they may induce motion.

Motion Studies provides the following type of force elements:
  • Gravity.
  • Springs, dampers, friction, and bushings. Forces apply to translational springs, torsion springs, translational dampers, torsion dampers, static friction, dynamic friction, joint friction, and bushings.
  • Forces. Applied forces in SOLIDWORKS Motion define loads and compliances on parts so that they move in certain directions. You must select the type of Force Function and its parameter values. You can also use mathematical expressions for forces. You can apply combinations of Linear force or Torque.
  • Contact. Forces are generated between contacting components, or components are constrained to touch continually. Define contact to prevent the components from passing through each other during the motion analysis.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Motion Study Elements Overview
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.