Hide Table of Contents

Unmerging Sketch Endpoints with Detach Segment on Drag

You can unmerge sketch entity endpoints with Detach Segment on Drag.

Previously, with Detach Segment on Drag, you could drag any sketch entity and detach it from other entities, but you could not detach an entity at just one endpoint.

To unmerge sketch endpoints with Detach Segment on Drag:

  1. Open any sketch with segments or closed spline endpoints.
  2. Right-click the entity to detach and click Detach Segment on Drag .
    The endpoints change to a different color when you select the entity with merged points.
  3. Drag the endpoint to the desired location.
  4. Right-click the entity and clear Detach Segment on Drag.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Unmerging Sketch Endpoints with Detach Segment on Drag
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.