Hide Table of Contents

Selecting Midpoints with Dynamic Highlighting

You can dynamically highlight and select midpoints on sketch entities and model edges to add relations. You can also dynamically highlight and select midpoints of sketch entities while dimensioning in sketches.

Previously, you could only select midpoints of model edges while dimensioning using Select Midpoint from the shortcut menu. However, on selection of a second midpoint on another entity, the first entity was cleared.

To select midpoints with dynamic highlighting:

  1. Hover over a midpoint on a sketch entity or model edge.
    The entity and its midpoint are highlighted.
  2. Select the midpoint.
    Selecting midpoints with dynamic highlighting is only available for lines, arcs, and model edges in sketch mode.
    Dynamic highlight of the midpoint of a sketch entity
    Dynamic highlight of the midpoint of a model edge


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Selecting Midpoints with Dynamic Highlighting
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.