Hide Table of Contents

Design Studies in SOLIDWORKS

You can evaluate and optimize models by using a Design Study.

There are two main modes for running a Design Study:

Evaluation

You specify discrete values for each variable and use sensors as constraints. The software runs the study using various combinations of the values and reports the output for each combination.

For example, for this multibody model of a water bottle, you specify values of 75mm, 100mm, and 150mm for the length (L); 30mm, 55mm, and 80mm for the height (H); and 10mm and 20mm for the radius (R). You specify a Volume sensor to monitor the volume of the water body. The Design Study results report the volume of the water for each combination of L, R, and H.



Optimization

You specify values for each variable, either as discrete values or as a range. You use sensors as constraints and as goals. The software runs iterations of the values and reports the optimum combination of values to meet your specified goal.

For example, for the model above, you specify a range of 75mm to 150mm for the length (L); discrete values 30mm, 55mm, and 80mm for the height (H); and a range of 10mm to 20mm for the radius (R). For a constraint, you specify a Volume sensor to keep the volume of the water body between 299000mm^3 and 301000mm^3. For a goal, you use a Mass sensor and specify to minimize the mass of the bottle. The Design Study iterates on the values specified for L, R, H, and Volume, and reports the optimum combination to produce minimum mass.

Different sensors are available for use in Design Studies depending on your SOLIDWORKS license and whether you are running an Evaluation study or an Optimization study.

  SOLIDWORKS Standard SOLIDWORKS Professional SOLIDWORKS Premium SOLIDWORKS Simulation Professional SOLIDWORKS Simulation Premium
  Evaluation Optimization Evaluation Optimization Evaluation Optimization Evaluation Optimization Evaluation Optimization
Mass Properties
Dimension
Simulation Data          

After running a study, select a scenario or iteration on the Results View tab. In the graphics area, the model updates with the values for that scenario or iteration.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Design Studies in SOLIDWORKS
*Comment:  

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP02

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2017 SP02.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.