Inserting Weldment Cut List Tables in Drawings

To insert a weldment cut list table into a drawing:

  1. In a drawing, click Weldment Cut List Tool_Weldment_Cut_List_Table.gif (Table toolbar) or Insert > Tables > Weldment Cut List.
  2. Select a drawing view.
  3. Specify properties in the Weldment Cut List PropertyManager, then click PM_OK.gif.
  4. If you did not select Attach to anchor point in the PropertyManager, click in the graphics area to place the cut list.
    You can insert multiple cut lists in a drawing sheet.
    Be sure to trim structural members in the part document so that correct lengths appear on the cut list in the drawing. For example, use Trim/Extend tool_Trim_Extend_Weldment.gif (Weldments toolbar) to trim both ends of the cross member flush with the faces of the side members so the correct length (270) appears on the cut list.
    weldment_cutlist_before_trim.gif
    Before trimming
    weldment_cutlist_after_trim.gif
    After trimming