Hide Table of Contents

Grooves - O-Ring Grooves

The O-Ring Grooves tab lets you select and create standard O-ring grooves.

To open this tab:

Click Grooves (Toolbox toolbar) or Toolbox > Grooves.

Groove Selection

Select a groove from the lists in the top left corner.

Standard  
Type  
Size  
Sketch Displays a sketch of the selected groove type.

Properties

Read-only properties for the selected groove.

Description Describes the groove.
Selected Diameter Displays the diameter of the selected cylindrical face, or No selected diameter.
Mate Diameter Displays a reference value for the diameter of the non-grooved mating part that completes the seal.
Groove Diameter (A)

Width (B)

Radius (C)

(A) is shown as a radius rather than a diameter.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Grooves - O-Ring Grooves
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48