Hide Table of Contents

Effects of Design Changes on Pressure and Cooling

This table summarizes the effect of design changes on the processability of a part.

Part/Mold/Material design change Pressure Required to Fill Cooling Time
Increase wall thickness Decrease Increase
Decrease wall thickness Increase Decrease
Increase flow length (change gate location) Increase N/A
Decrease flow length (change gate location) Decrease N/A
Add gates Decrease N/A
Add reinforcements (glass fiber) Increase N/A
Add colorant Increase or Decrease N/A


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Effects of Design Changes on Pressure and Cooling
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Plastics 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.