Ellipse PropertyManager

To open this PropertyManager:

In an open sketch, select an ellipse.

Existing Relations

	Relations	Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area.
	Information	Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.

Options

Parameters

You can specify any appropriate combination of the following parameters to define the ellipse if the ellipse is not constrained by relations. When you change one or more parameters, the other parameters update automatically. Some parameters are available only for a partial ellipse.

	Center X Coordinate
	Center Y Coordinate
	Start X Coordinate	(partial ellipse only)
	Start Y Coordinate	(partial ellipse only)
	End X Coordinate	(partial ellipse only)
	End Y Coordinate	(partial ellipse only)
	Radius 1
	Radius 2
	Angle	(partial ellipse only)