Property UseBaselineDimensions As System.Boolean

Dim instance As IAdvancedHoleFeatureData
Dim value As System.Boolean
 
instance.UseBaselineDimensions = value
 
value = instance.UseBaselineDimensions

System.bool UseBaselineDimensions {get; set;}

property System.bool UseBaselineDimensions {
   System.bool get();
   void set ( &   System.bool value);
}

Property Value

If you set this property to true, then you can get and set:

• ICounterboreElementData::UseStandardDepth
• ICountersinkElementData::UseStandardDepth
• ITaperedTapElementData::UseStandardDepth
• IStraightTapElementData::Equation (for the Offset From Surface end condition only)

but you cannot set any end conditions or end condition overrides.

If you set this property to false, then the UseStandardDepth properties above are not valid, but you can get and set:

• ICounterboreElementData::EndConditionOverride
• ICountersinkElementData::EndConditionOverride
• ITaperedTapElementData::EndConditionOverride
• IAdvancedHoleElementData::EndCondition (only if the corresponding EndConditionOverride for the element is set to true)
• IAdvancedHoleElementData::BlindDepth (for the Blind end condition only)
• IStraightTapElementData::Equation (for the Blind end condition only)