Hide Table of Contents
FeatureManagerSplitterPosition Property (IModelDoc2)

Splits the FeatureManager design tree and gets or sets the location of the split bar in the FeatureManager design tree panel.

.NET Syntax

Visual Basic (Declaration) 
Property FeatureManagerSplitterPosition As System.Double
Visual Basic (Usage) 
Dim instance As IModelDoc2
Dim value As System.Double
 
instance.FeatureManagerSplitterPosition = value
 
value = instance.FeatureManagerSplitterPosition
C# 
System.double FeatureManagerSplitterPosition {get; set;}
C++/CLI 
property System.double FeatureManagerSplitterPosition {
   System.double get();
   void set ( &   System.double value);
}

Property Value

Percentage value between 0 and 1, which sets the location of the split bar in the FeatureManager design tree panel and the size of each split FeatureManager design tree (see Remarks)

Example

Remarks

Setting this property to... Results in the split panel bar...
0 Remaining above the FeatureManager design tree.
1 Moving below the FeatureManager design tree.
>0 and <1

Setting the size of the split FeatureManager design trees within the FeatureManager design tree panel.

For example, if you specify:

  • 0.5, then each FeatureManager design tree takes up 50 percent of the panel, and the split bar is located between them.
  • 0.8, then the bottom FeatureManager design tree takes up 80 percent of the panel, the top FeatureManager design tree takes up 20 percent of the panel, and the split bar is located between them.

See Also

Availability

SOLIDWORKS 2001Plus FCS, Revision Number 10.0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   FeatureManagerSplitterPosition Property (IModelDoc2)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2018 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59